Corn Puff Extruder-manufacture,factory,supplier from China

There is only one screw in the barrel of the single screw extruder, it is by the friction of the screw and the barrel of the material to transport materials and form a certain pressure. In general, the friction coefficient between the material and the barrel is greater than that between the material and the screw. Otherwise, the material will be wrapped in the screw together to rotate and not play the role of forward propulsion.Screw is divided into three sections: feeding (feeding) conveying section, compression melting section, metering homogenization section.

1. Before operating the corn equipment bulking machine, remove the head, movement, lead screw and other parts, clean them up, dry them and then install them.2. Idling for 1 to 2 minutes first when operating, put the raw materials into the feed mouth, not too fast, when the ring groove of the spiral shaft head is filled, stop feeding, friction preheating. Wait until the nose temperature rises and the pressure inside the cabin builds up before feeding.3. Feed should be continuous and uniform, material must be dry, must pay attention to.4.

　　The puff snack extruder has two pairs of screws that mesh with each other and rotate in the same direction. They jointly play the roles of conveying, friction extrusion and heating. The materials are input by the principle of positive displacement for forced conveying, and pressure backflow is rarely formed.　　Thus, the problem in this respect on the single screw extrusion extruder is better solved, and strong conveying. puff snake extruder integrates compression, mixing, mixing, shearing, melting, sterilization, expansion, molding and other functions, and is completed in a very short time.

For extruder equipment, the model specifications of extruder equipment are classified according to the diameter of the screw. For the sake of explanation, plastic is used as an example below, but the same is true for food extruders.That is to say, the screw diameter of the extruder equipment is the model specification of the extruder equipment. For example, the screw diameter of the 90-type extruder equipment is 90mm.

　　The products produced by the breakfast cereal production line are a brittle food with a smooth taste and a strong grain flavor. Breakfast cereal corn flakes are processed by a special structured extruder, which further improves yield, quality, and raw material adaptability compared to traditional production methods, making it possible to strengthen trace elements such as vitamins and minerals. This production line has the characteristics of multiple optional models, flexible equipment configuration, wide range of raw materials, multiple product types, and simple operation.

Corn chip is a kind of brittle food, with good rehydration, external flushing not rotten, smooth taste, grain flavor rich.

Extruder belongs to a kind of equipment for processing puffed food. It is a kind of equipment for processing puffed food, such as processing rice, corn, soybean, wheat, etc., in daily life.

Twin screw extruder to keep clean can produce better products, keep clean can also reduce the occurrence of failure rate, ensure the continuous production, twin screw extrusion equipment maintenance basic elements - inspection, cleaning.The inner wall of cooling water pipe attached to twin screw extrusion equipment is easy to scale, and the outside is easy to rust and corrosion. The maintenance should be carefully checked.

The screw extruder was first used in the plastics industry, and its theoretical research started earlier, forming a variety of mathematical models used to describe the basic principles of flow and heat transfer in the extrusion process, using these models to achieve accurate extrusion machine simulation Design. The application of extrusion technology in the food industry is slightly later than that in the plastics industry, which is mainly due to the complexity of food raw materials.

Directly puffed food is generally required to be dried after extrusion processing. The moisture content of the dough in the extruder is 15%~20%. The product is then dried to reduce the moisture content to 2% to 3% to create the environment needed for a crunchy texture and stable shelf life. Due to the low density of the product, the drying time is usually very short, so it should be carried out in a warm warehouse.Coatings to produce direct-expanded products Extruded and dried products are finally sprayed with oils and seasonings.